Thankyou
1 more question
Z offset
So right now I have my z min endstop at 0 on the bed, then I adjusted the springs to get .2mm which I've been doing for years.
If I move my endstop let's say 1mm below bed, where would I enter the z offset to get me back to .2mm above the bed. Could I then enable
babystepping which would give me live z movement?
1 more question
Z offset
So right now I have my z min endstop at 0 on the bed, then I adjusted the springs to get .2mm which I've been doing for years.
If I move my endstop let's say 1mm below bed, where would I enter the z offset to get me back to .2mm above the bed. Could I then enable
babystepping which would give me live z movement?