I use baby-stepping to assist me in live Z-Offset movement.
This is the main reason I enabled baby-stepping. When I first start the 3D Print I can adjust Z-Offset during the single skirt to make the fine adjustments needed for that perfect first layer.
This is one reason I print the first layer at 32% print speed, it allow me ample time to get this adjustment correct.
Mind you that most of the time auto-bed leveling and the Z-Proximity Sensor Adjustable slide mount set this correctly, but it only takes a few seconds to make that determination.
Then when it is incorrect I am there to make the Z-Offset baby-stepping adjustment, and no wasted print time.
This is the main reason I enabled baby-stepping. When I first start the 3D Print I can adjust Z-Offset during the single skirt to make the fine adjustments needed for that perfect first layer.
This is one reason I print the first layer at 32% print speed, it allow me ample time to get this adjustment correct.
Mind you that most of the time auto-bed leveling and the Z-Proximity Sensor Adjustable slide mount set this correctly, but it only takes a few seconds to make that determination.
Then when it is incorrect I am there to make the Z-Offset baby-stepping adjustment, and no wasted print time.