Hello all,
i tried to set up the filament width sensor function to test it before using it with the following setup:
REARM board with Ramps 1.6 addon ... REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER ... No SDSupport
I have replaced the sensor by a poti. I get a filament width shown on the display but ... I need to have an input voltage of round about 0.5V that the display shows 1.75 mm ... i have used a 25 turn poti and it is more or less impossible to set an exact value because it is so sensitive ... i´m talking about ~0.2V from 2,5mm to 0,5mm.
I hope someone can help me.
BR Andy
i tried to set up the filament width sensor function to test it before using it with the following setup:
REARM board with Ramps 1.6 addon ... REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER ... No SDSupport
I have replaced the sensor by a poti. I get a filament width shown on the display but ... I need to have an input voltage of round about 0.5V that the display shows 1.75 mm ... i have used a 25 turn poti and it is more or less impossible to set an exact value because it is so sensitive ... i´m talking about ~0.2V from 2,5mm to 0,5mm.
I hope someone can help me.
BR Andy