Hi
thanks for the reply
i have downloaded U8Glib and added to my libery dose the need to be put in anywhere secific as if i add it to the sketch it puts it in at the very top of the config.h file. also can i just type in the command for that.
i am not sure what the issue is with the drivers as i didn't have any motors connected to the board when they burn out so that may require further investigation once i get the firmware sorted out.
i shall try to right the new code to it tomorrow as i do not have my windows pc handy and my mac will not read communicate with the Arduino but i know what the issue is there tho
manny thanks
Best regards
Adam
thanks for the reply
i have downloaded U8Glib and added to my libery dose the need to be put in anywhere secific as if i add it to the sketch it puts it in at the very top of the config.h file. also can i just type in the command for that.
i am not sure what the issue is with the drivers as i didn't have any motors connected to the board when they burn out so that may require further investigation once i get the firmware sorted out.
i shall try to right the new code to it tomorrow as i do not have my windows pc handy and my mac will not read communicate with the Arduino but i know what the issue is there tho
manny thanks
Best regards
Adam