Re: DEFAULT_AXIS_STEPS_PER_UNIT Above 999 - T8x2 Leadscrew

Thanks for the reply.

When I set at 1600 it only shows 600 and behaves as if it was set to 600 as well. I got those leadscrews T8x2 because I wanted to print slow but very accurate large prints (time wasn't a concern on the design)

I guess I will have to switch the T8x2 for the T8x8 four starts

I wonder if there is any way to change the microstepping so like 1/8 so I could use 800 instead.. but I don't have any manuals for this MKS board I have here...

Thanks


Marcos.