Thanks for the reply.
My current setup is an Arduino mega with ramps 1.4 and TMC2130 drivers.
I guess 32bit is the way to go with a new build? I hadn't realised Marlin 2.0 would run on an 8 bit chip.
For the rest of the hardware I'm looking at the bear upgrade frame with mk52 bed and E3D Hemera.
I'm not likely to want more than one extruder.
My current setup is an Arduino mega with ramps 1.4 and TMC2130 drivers.
I guess 32bit is the way to go with a new build? I hadn't realised Marlin 2.0 would run on an 8 bit chip.
For the rest of the hardware I'm looking at the bear upgrade frame with mk52 bed and E3D Hemera.
I'm not likely to want more than one extruder.