Running a Printrboard Rev.D, just meticulously went through configuration.h
Uploaded it to the board and that was successful
But it either appears to not be booting, or not communicating
None of the host software that I've tried (Repetier. Octoprint) can connect to it.
Appears to be only an issue with Marlin RC6, I can upload Repetier Firmware as well as the latest stable Marlin 1.0.2-1 and it's fine.
I've posted it as an issue on the Github and no response, wondering if anyone else has seen this or has a suggestion
Uploaded it to the board and that was successful
But it either appears to not be booting, or not communicating
None of the host software that I've tried (Repetier. Octoprint) can connect to it.
Appears to be only an issue with Marlin RC6, I can upload Repetier Firmware as well as the latest stable Marlin 1.0.2-1 and it's fine.
I've posted it as an issue on the Github and no response, wondering if anyone else has seen this or has a suggestion