Trying to switch from mothebroard 34 to 33 in config.h

Want to see what all this cooling fan talk is about. I changed my configuration motherboard line from 34 to 33 but now it will not compile.

error log
[justpaste.it]

and this is a copy and paste of where the code breaks compiling..
[justpaste.it]

Compiles fine if I go back to 34 motherboard. Any help is appreciated.



.:Edit:.

Downloaded a fresh distro of Marlin and imported all the settings one at a time. There is one command that fails to compile..

#define DISABLE_MAX_ENDSTOPS

That is needed because otherwise X Y and possibly Z(didn't test) only go in one direction and the end stops do not work.

There error log says...

DISABLE_MAX_ENDSTOPS is deprecated use 'USE_*_PLUG' command.

i can't google on 'USE_*_PLUG' and results are few to say the least. My google syntax may be lacking so if you can help that would be great.


.:Edit:.

Figured it out. Gonna post the newer firmware in case other 3D Cloner users might want to try it out after it's been tested a bit.