I tried to start using Linear Advance in the new Marling. I calibrate everything and tried in the firmware code to set K to 40. When I then compile in Arduino IDE I get this message: LIN_ADVANCE_K must be a value from 0 to 10 .
If I use 4.0 then every thing is OK but I don't now the effect at printing.
I also have this error when activate the linear advance: #error "LIN_ADVANCE (1.5) no longer uses LIN_ADVANCE_E_D_RATIO.
What i'm doing wrong.
Regard
Ola A
If I use 4.0 then every thing is OK but I don't now the effect at printing.
I also have this error when activate the linear advance: #error "LIN_ADVANCE (1.5) no longer uses LIN_ADVANCE_E_D_RATIO.
What i'm doing wrong.
Regard
Ola A