thanks for the reply. maybe i was not specific enough- yes, i understand that i should be somewhere around 0 for the mesh points. this is how things were looking when i first got the probe.
my Z probe trigger heights have been slowly but steadily creeping up. when i got the probe, it was triggering around 2.6mm. when things started going weird, i backed-up and calibrated. then i got like 2.8mm. things worked for a while, then got weird again. i recalibrated then i got a value of 3.2mm. then again after a few days, until i have gotten up to 3.8mm.
did you watch the video? what would cause the probing to go the other way? points 6, 7, & 8 dont retract/return like they should.
i am trying to figure out if this is a probe issue or marlin issue.
my Z probe trigger heights have been slowly but steadily creeping up. when i got the probe, it was triggering around 2.6mm. when things started going weird, i backed-up and calibrated. then i got like 2.8mm. things worked for a while, then got weird again. i recalibrated then i got a value of 3.2mm. then again after a few days, until i have gotten up to 3.8mm.
did you watch the video? what would cause the probing to go the other way? points 6, 7, & 8 dont retract/return like they should.
i am trying to figure out if this is a probe issue or marlin issue.