I have a tevo tarantula printer and i have marlin easyconfig flashed. My board is the mks 1.4 . Here is my issue.. no matter if i am heating the nozzle or the heatbed, both temps read the same temperature. So if i start heating the heatbed both temp readings on the lcd slowly go up until it hits the heatbed temp and stops.. though just the heatbed was heated. If i heat just the nozzle, both temp readings on the lcd go up faster until the nozzle is at temp and then stops..though just the nozzle was heated. So if i start by clicking preheat pla, both nozzle and heatbed start heating though the temps on the display are rising at nozzle speed so when they hit 70 (my heatbed setting) the heatbed turns off though in reality the heatbed is only 30 or so degrees.. the heatbed wont turn back on because both temperature readings on the display read 210(my nozzle setting)... both thermosistor wires are plugged in to thier respective slots on the mks 1.4 .. the nozzle sensor in the top slot and the heatbed sensor in the second slot.. can anyone help with this?
↧
