Home position switches are to the back right, also X0 Y0 are back right. The Z probe is in front and to the left of the nozzle on the opposite side as the home position limit switches. The travel limits after homing are the offset from the nozzle to the probe in X and Y. When it homes and runs the bed leveling procedure the XY0 is shifted away from the limit switches by the amount of the probe offset. This shortens my useable print area by a lot. If i set the MIN positions to 0 instead of the probe offset distances i get an error when compiling. This is the only way i can get everything to jive where it will compile correctly without fudging numbers. I can set the probe offsets to 0 and set the MIN positions to 0 and everything will then work prefect. However the probe offset will not be accounted for which means the results of the bed mesh will be incorrect.
There has to be a better way to do this. Maybe im just not getting it, i dont know but i cant be the first one to have this trouble.
There has to be a better way to do this. Maybe im just not getting it, i dont know but i cant be the first one to have this trouble.