I'm stuck... I am sure the problem is something simple that I am missing, I recently switched from Repetier to Marlin to take advantage of the TCM 2130 Drivers. All of my electronics (Arduino Mega/Ramps 1.4/ Drivers) are fresh and I have trouble shot everything else. The X/Y/E0 work perfectly (the homing options on these drivers are amazing), However I have zero power on my Z I checked both motors (they light an LED when turned manually) with the printer on I can move the Z-axis freely as if there is no power. I checked my Z pins with a multimeter and I am getting nothing out of the board, Its as if the firmware has them disabled by default somewhere. I have never used Marlin before and cant seem to find anything piece of code that might cause this problem, I have attached a Text file of my Config.h (all of the unrelated variables have been left at Marlin's defaults). Any help would be greatly appreciated, I have built about 5 printers and this thing (Mendel Max 2 frame my neighbor found in a dumpster) has been giving me a hard time at every step. Thanks!
↧