Since it's printing now and has been for about three hours, the temp of hotend 1 (which is not being used or heated right now) is a bit off, but I believe the typical starting temps are in the 20C range, give or take a degree or two. I'll double check in the morning when everything has cooled off and stabilized.
I did read about 'Bang-bang' vs PID mode, and I believe it's set to 'bang-bang' mode, and apparently, PID mode can help with this. It seems PID mode might be better overall - is enabling that a simple uncomment a line, or is there more to it (like a few lines)?
I did read about 'Bang-bang' vs PID mode, and I believe it's set to 'bang-bang' mode, and apparently, PID mode can help with this. It seems PID mode might be better overall - is enabling that a simple uncomment a line, or is there more to it (like a few lines)?
