I just got a 3d printer by Createbot, a Prusa i3 clone, that I have their firmware for (albeit it was broken as sent to me and I had to fix it to get back to square one), and it works, but I'm interested in trying out the 'real' Marlin 1.0 or 1.1 firmware - I can't imagine there aren't improvements since the 1.0.0 RC2 that is apparently running on my controller (this one, that is set up as Motherboard '33' in their firmware). But when I try to build the 1.0 or 1.1 versions, I get errors. If I try to build them as opened from the zip files as downloaded, they compile fine - but once I go through the firmware that they sent me and modify settings as needed (I think the 'killer' here is dual extruders..), when I try to compile, it fails.
Any suggestions as to what I need to do to port the CBot 'version' of Marlin (if it's really anything 'special' other than a REALLY old version of Marlin) over to the latest 1.0 branch or maybe the 1.1 branch of Marlin? Like I basically said earlier, Marlin hasn't gone from 1.0.0 RC2 (that is on my controller) to 1.1.x without improvements and/or enhancements.
Any suggestions as to what I need to do to port the CBot 'version' of Marlin (if it's really anything 'special' other than a REALLY old version of Marlin) over to the latest 1.0 branch or maybe the 1.1 branch of Marlin? Like I basically said earlier, Marlin hasn't gone from 1.0.0 RC2 (that is on my controller) to 1.1.x without improvements and/or enhancements.