I have had problems after flashing if I did not reload firmware defaults. You can do this by simply. sending a M502 then sending M500.
Or you can send a M502 ( Factory Reset ), M501 ( Restore Settings ) and then M500 ( Save Settings ).
Not sure why but the old setting are not always cleared when flashing, not resetting can lead you to experience some unwanted side effects)
:NOTE this can only be accomplished if you enable ( EEProm )
Or you can send a M502 ( Factory Reset ), M501 ( Restore Settings ) and then M500 ( Save Settings ).
Not sure why but the old setting are not always cleared when flashing, not resetting can lead you to experience some unwanted side effects)
:NOTE this can only be accomplished if you enable ( EEProm )