I tried it and the same outcome but 1.1.x is just screwed up as I turned off the machine then realized I had left Z up by 10 due to G28 X. I go back in and do a G92 Z10 and it would not go down only up but after I had upped it the machine would go down but never down below whatever I set G92 Z to. So I did a M114 and Z said 10. I am not sure what is going on but 1.1-RC3 works whereas 1.1.6 does not.Quote
Roberts_Clif
With Marlin baby steps, I can move the nozzle Z height using u-step by u-step up/down on the fly directly from a LCD controller turn and click knob.
So let's say I start a print with a brim and notice it is a little off I can quickly move one of the axis to perfection using LCD Babystepping.
This allows me to quickly adjusting for the Z-Axis until I get that perfect adhesion height.
Individual Axis Homing Menu is the same as G28 X, G28 Y or G28 Z only from the LCD display.
↧
Re: 1.1.6
↧