Re: Auto Bed Leveling doubt

Hi Roxy,

Yes, everything is moving to the right direction. I am using Repetier host.

Yesterday I downloaded the new FW version (1.1.6) and, before sending it to MEGA, I had to reconfigure several parameters. Taking advantage of this, I have also enabled Unified Bed Leveling.

So, I sent a M502 / M500 to store the parameters into the EEPROM, G28 to home the axis and then I sent a G29 P1 to begin the automated procedure. What I could notice is that it seems several points are being taken in the "air". What I mean is that I was expecting the proble to go all the way down until it touches the bed and then proceed to the next point. This happens from time to time (going all the way to the bed and triggering the endstop) but sometimes I see the probe going down, then it stops above the bed (let´s say 30 mm) and then it moves to the next point.

Could you explain what to expect after the G29 P1? Does the probe touch the bed right after the G29 P1 (after moving to X and Y)?

Thanks once again for your clarifications.

Marcus