Re: heat bed stops the print

Hi.

thanks for your help.

i change to PIDTEMPBED and run the test to get the values to store in the firmware.
but no luck.

i also change the BED_MAXTEMP to 110

i will check the wiering,

question. if the wiering is bad what puzzles meis that the print stops almost in the same high.

another question i have the hot end fan (E3dv6) and also 2 more fans for cooling the filament, can it be to much air blowing in to the center of the bed and this causing cooling the bed.

image attach of the hot end

regards