Guys I need some help here.
For a long time I have used RAMPS on my Prusa I3 but I decided to make some upgrades, then I bought a RAMBo and installed it on my printer.
The point is that I can't upload the firmware (Marlin), I have choosen the right board and followed a youtube tutorial.
But It keeps showing this error:
stepper.cpp:1534: error: 'DIGIPOT_MOTOR_CURRENT' was not declared in this scope
How can I fix that? Thank you!
For a long time I have used RAMPS on my Prusa I3 but I decided to make some upgrades, then I bought a RAMBo and installed it on my printer.
The point is that I can't upload the firmware (Marlin), I have choosen the right board and followed a youtube tutorial.
But It keeps showing this error:
stepper.cpp:1534: error: 'DIGIPOT_MOTOR_CURRENT' was not declared in this scope
How can I fix that? Thank you!