Quote
Roberts_Clif
Quote
JustSumGuy
sounds like the controller then.
I thought is was the controller also so I replaced with my backup controllers, to which I have one for each 3D Printer.
If it is bad then I have 4 bad Controllers, all with the same errors.
All working with HICTOP i3 Mendel v1.1.0-RC8. and like I said they work in Marlin 1.1.5 they just display the " Endstops Z " or "G28 Z Forbidden" and CRC memory error on M500.
You know it's crazy I am still on Marlin 1.1.X will be trying Marlin 1.1.1 thru 1.1.3 till I find where it starts erring. I know Marlin 1.1.4 and above errors.
Compiled Marlin 1.1.1 displays " Endstops Z " error however no CRC memory error will step tomorrow to Marlin 1.1.2 to duplicate memory error.
To Contuine
Setup and Complied Marlin 1.1.2 displays " Endstops Z " error and A CRC memory error -8370 ://Crazy error actually Marlin 1.1.2 is using 64bytes less memory than Marlin 1.1.1
forgot to mention both display in pronterface "echo:endstop hit: Z0.50"
Just need to get the code changes for both Marlin 1.1.1 and Marlin 1.1.2 And determine what line were affected to correct the displayed " Endstops Z " and memory CRC error.
Does anyone know where I can download just the updated code changes for these versions from Marlin 1.1.0 to Marlin 1.1.1 to Marlin 1.1.2
Thank You