Quote
JustSumGuy
There is not enough room in the cube frame to install a probe that I can work out yet.
I placed my Probe under the extruder frame with an adjustable bearing mount slide. With a low profile Proximity Sensor Omron TL-W3M it is within 25mm of the Nozzle.
Could have been 15mm closer thou could not see a purpose. Decided on a 3mm sensor and connect to 5Volt supply.
They to have from 1.5mm - 5mm sensors available. Way smaller than the SN04-N that came with the Printer.
[attachment 98082 HotEndCooling.jpg]