Quantcast
Channel: Reprap Forum - Firmware - Marlin
Viewing all articles
Browse latest Browse all 12090

Re: 1.1.5 getting mesh bed leveling working

$
0
0
You manually lower the nozzle to a piece of paper, click the menu button it goes to the next location. you lower the nozzle to the piece of paper ect...
Until you reach the end of the bed.

usually with this type of bed leveling you only use a few points three, four or five.

I included a video in the above post.

Viewing all articles
Browse latest Browse all 12090

Trending Articles