I have downloaded a copy of the Marlin firmware version currently installed in my printer (Lulzbot TAZ 6) mostly for my own education.
I can look at the source code but because of the heavy dependency on conditional compilation, its a lot of work to determine exactly which code is actually being used.
Is it possible to use the C pre-processor to generate the actual source code that will be compiled based on the settings in configuration.h, etc.? If it is possible, some guidance on how would be appreciated.
Any other suggestions on how to ease the effort needed to understand what code is actually being used?
My primary system is Windows 10, but I have Linux machines that I can use.
I can look at the source code but because of the heavy dependency on conditional compilation, its a lot of work to determine exactly which code is actually being used.
Is it possible to use the C pre-processor to generate the actual source code that will be compiled based on the settings in configuration.h, etc.? If it is possible, some guidance on how would be appreciated.
Any other suggestions on how to ease the effort needed to understand what code is actually being used?
My primary system is Windows 10, but I have Linux machines that I can use.