I have recently built a Hictop 3D printer:
[www.amazon.co.uk]
All working fine. Have tried to add a BLTouch sensor but have run into difficulty.
Have replaced the main control board with an MKS 1.4:
[www.amazon.co.uk]
Wired according to instructions:
[talmcmahon.com]
Having recompiled and uploaded laterst Marlin v1.1 the BLTest menu option causes the BLTouch to pulse several times. It starts up with a self-test, so I suspect the hardware config is broadly okay.
However I can't get it to trigger/deploy when homing. Have tried many config settings but it never homes so I can't set my Z height (the Hictop sensor supplied works fine).
Probably a config issue which I have overlooked. My Configuration.h file is attached.
[www.amazon.co.uk]
All working fine. Have tried to add a BLTouch sensor but have run into difficulty.
Have replaced the main control board with an MKS 1.4:
[www.amazon.co.uk]
Wired according to instructions:
[talmcmahon.com]
Having recompiled and uploaded laterst Marlin v1.1 the BLTest menu option causes the BLTouch to pulse several times. It starts up with a self-test, so I suspect the hardware config is broadly okay.
However I can't get it to trigger/deploy when homing. Have tried many config settings but it never homes so I can't set my Z height (the Hictop sensor supplied works fine).
Probably a config issue which I have overlooked. My Configuration.h file is attached.