Progress. Of a sort.
I managed to get a useable print whilst printing from cura on USB.
On average the dimensions were within 0.4 mil of the 20mm box.
then without making any changes i tried to print the 20mm test box again, this time from sd card to have the non extrusion issue again.
Since then still no good prints, regardless of printing from usb or sdcard.
I even let it sit at printing temp for 20 odd mins while i re-levelled the bed with my feeler gauge set to 0.2. (half my 0.4 nozzle size.) to make sure it's not heat expansion.
Im getting so frustrated it's not even amusing anymore.
I managed to get a useable print whilst printing from cura on USB.
On average the dimensions were within 0.4 mil of the 20mm box.
then without making any changes i tried to print the 20mm test box again, this time from sd card to have the non extrusion issue again.
Since then still no good prints, regardless of printing from usb or sdcard.
I even let it sit at printing temp for 20 odd mins while i re-levelled the bed with my feeler gauge set to 0.2. (half my 0.4 nozzle size.) to make sure it's not heat expansion.
Im getting so frustrated it's not even amusing anymore.