Hello Obewan,
no translation/translator now!
I have tested with 3 and the Z motors were complaining and buzing!
so now on 2.5 it is okee and I start A test print forloking waht the printer wil do.
.
it goes/printing well!
only the infill speed is verry hi
it goes well
Only the speed
Of the fill is going (I think!) too fast!
this is because Marlin??? or in this case Cura??? The settings.
BUT!!! He is doing it very well now!
HOOWWWWwwwwwwwwwwwww
I did not must have say that...... afterwards!
Now the printer is missing a step during printing (Just looking at it) ;-)
I think the printer (the workpiece) can still be used
In other words, I have to do something about that speed (The infill speed)
Strange!
he has below the center of the workpiece
6 layers shifted laid down,
And after that the printer went well again?
till so far.
Rob.
no translation/translator now!
I have tested with 3 and the Z motors were complaining and buzing!
so now on 2.5 it is okee and I start A test print forloking waht the printer wil do.
.
it goes/printing well!
only the infill speed is verry hi
it goes well
Only the speed
Of the fill is going (I think!) too fast!
this is because Marlin??? or in this case Cura??? The settings.
BUT!!! He is doing it very well now!
HOOWWWWwwwwwwwwwwwww
I did not must have say that...... afterwards!
Now the printer is missing a step during printing (Just looking at it) ;-)
I think the printer (the workpiece) can still be used
In other words, I have to do something about that speed (The infill speed)
Strange!
he has below the center of the workpiece
6 layers shifted laid down,
And after that the printer went well again?
till so far.
Rob.