Quote
pringleman
but is there a setting I should know about to change the width of the platform.
For Delta Printers you control this with DELTA_PRINTABLE_RADIUS and DELTA_PROBEABLE_RADIUS. For Cartesian printers, it is controlled by this: (Please ignore the fact this is using Delta numbers)
// Travel limits after homing (units are in mm)
#define X_MIN_POS (-DELTA_PRINTABLE_RADIUS)
#define Y_MIN_POS (-DELTA_PRINTABLE_RADIUS)
#define Z_MIN_POS 0
#define X_MAX_POS DELTA_PRINTABLE_RADIUS
#define Y_MAX_POS DELTA_PRINTABLE_RADIUS
#define Z_MAX_POS MANUAL_Z_HOME_POS
#define X_MAX_LENGTH (X_MAX_POS - X_MIN_POS)
#define Y_MAX_LENGTH (Y_MAX_POS - Y_MIN_POS)
#define Z_MAX_LENGTH (Z_MAX_POS - Z_MIN_POS)
