ok , i am back on. lcd works. i setup the wrong board on config.h i setup ramp_14EFB , i also setup the pin z_probe_pin to 18 pin18 its the z_min_pin do i need to disable the z_min_pin or not.
the z axis works when i press home but if i hit home all axis the X Y axis reset to 0 and then moves to center plate and z axis goes down with out stopping.
one more thing after the 2 and 3 time i try to home z now it wont stop anymore but the probe light its on when i get a metal close. i am lost whats wrong ???
the z axis works when i press home but if i hit home all axis the X Y axis reset to 0 and then moves to center plate and z axis goes down with out stopping.
one more thing after the 2 and 3 time i try to home z now it wont stop anymore but the probe light its on when i get a metal close. i am lost whats wrong ???