So I made some experiments. I printed the same part at 0.06mm layer high with 60mm/sec print speed and 80mm/sec infill speed and the print was wonderful. Same thing for 0.1 mm high at 60mm/sec print speed and 60mm/sec infill speed. But, when I print at 0.2 mm layer high with 60mm/sec print speed and 60mm/sec infill speed then the extruder start to skip randomly. I posted some pictures with my settings for 0.2mm layer high. If it's not skippig at 0.06 and 0.1mm I'm thinking is not a hardware problem. What should I change? Thank you.
↧