Re: Bed Levelling on RC8 working but not compensating

And for completeness the debug output following G29
<-Bed Level Correction Matrix:
<-+0.999954 +0.000000 -0.009590
<-+0.000018 +0.999998 +0.001875
<-+0.009590 -0.001875 +0.999952
<- current_position=(115.00, 15.00, 12.30) : G29 uncorrected XYZ
<-Z from Probe:12.60 Matrix:12.60 Discrepancy:0.00
<- current_position=(115.00, 15.00, 12.60) : G29 corrected XYZ
<-<<< gcode_G29
<-X:115.00 Y:15.00 Z:12.60 E:16.16 Count X: 11500 Y:1500 Z:4920
<- current_position=(115.00, 15.00, 12.60) : sync_plan_position
<-ok
<-ok T:107.5 /0.0 B:24.0 /0.0 @:0 B@:0
->N281 M105*44

<-ok T:107.5 /0.0 B:24.0 /0.0 @:0 B@:0
->N282 M114*47

<-X:115.00 Y:15.00 Z:12.60 E:16.16 Count X: 11512 Y:1498 Z:4921
<-ok
->N1 M110 N1*125