Hi, I am trying to set up bed levelling with RC8, I have a Z Probe on the Z Min stop.
Everything works fine, Homing to Z fine, G29 fine, G29 reporting looks fine, but when I actually try a print then it homes XY, homes Z, runs the bed levelling (G29), but when it actually gets to printing there is no Z compensation for the bed levels. I.e. I have a bed that is high in the Front Right, during printing the head is squashed to the bed at the front right and far enough above the bed at Back left that the extrusion wont stick.
Any help really appreciated.
Everything works fine, Homing to Z fine, G29 fine, G29 reporting looks fine, but when I actually try a print then it homes XY, homes Z, runs the bed levelling (G29), but when it actually gets to printing there is no Z compensation for the bed levels. I.e. I have a bed that is high in the Front Right, during printing the head is squashed to the bed at the front right and far enough above the bed at Back left that the extrusion wont stick.
Any help really appreciated.