Hi Floyd!
Thanks for your response!
I will try the .2 layer height as you suggested and see what happens. The 230C I actually got from the paperwork (attached is a copy). From what I have read elsewhere, it is a minimum of 230C because of the transparent quality of the PLA. Read the attached and see if you agree...
My layer height for this cube was set to .3 though the paperwork suggests .4 for maximum transparency.
I do have the "stock" part cooling fan in place
Do you think the temp or the layer height is involved in the corners being the way they are? it almost looks like the nozzle is overshooting the corner...
Thanks again for you response!
Don W.
Thanks for your response!
I will try the .2 layer height as you suggested and see what happens. The 230C I actually got from the paperwork (attached is a copy). From what I have read elsewhere, it is a minimum of 230C because of the transparent quality of the PLA. Read the attached and see if you agree...
My layer height for this cube was set to .3 though the paperwork suggests .4 for maximum transparency.
I do have the "stock" part cooling fan in place
Do you think the temp or the layer height is involved in the corners being the way they are? it almost looks like the nozzle is overshooting the corner...
Thanks again for you response!
Don W.