Hi Obewan
You are absolutely correct. The "rear" of my bed when facing the front of the printer is where 0,0 is located. That was my initial stumbling block. One I set the "Front" of the printer at the left of the bed, everything starting falling into place.
It Seems as though people are finding this unusual though... Since it's my frist printer, not sure which corner is "supposed" to be home... can anyone enlighten me?
Thanks!
You are absolutely correct. The "rear" of my bed when facing the front of the printer is where 0,0 is located. That was my initial stumbling block. One I set the "Front" of the printer at the left of the bed, everything starting falling into place.
It Seems as though people are finding this unusual though... Since it's my frist printer, not sure which corner is "supposed" to be home... can anyone enlighten me?
Thanks!