Quote
Scott1326
Quote
gavatron3000
Hey mate I've had similar issues with this as well, I've found it hard to setup and the gcodes don't seem to respond correctly either, I abandoned the auto bilinear leveling and just stuck with manual mesh leveling and that works perfectly. It stores correctly and you only have to do it once, and use M420 S1 in your starting gcode to activate it each time. Plus it's very easy to adjust individual points to get a perfect mesh
Hi gavatron,
How exactly do you adjust the individual points after you've gone through the whole leveling procedure? I've been doing it with a G29 S3 xn yn zn command, which is a bit of a pain. Is there a way to edit one individual point through the lcd screen without having to do the whole thing over again?
Yes thats the way i did the editing.....i also made a spreadsheet with the mesh so if i lose it i can just type it back in, its done once then you dont need to worry about it which is fantastic. i was going to write a batch file to get the mesh from excel data and export in gcode format so i can just dump it into the terminal of octoprint