I set xhome direction from Min to Max in the firmware or -1 to 1.
Because I changed where the endstop was.
Now
When I hit xhome it goes still towards min(0)then stops after about an inch saying it hit max(200) without hitting an endstop.
No idea where I went wrong.
Should mention if I set it to -1 it has no problems besides going the completely wrong way.
Because I changed where the endstop was.
Now
When I hit xhome it goes still towards min(0)then stops after about an inch saying it hit max(200) without hitting an endstop.
No idea where I went wrong.
Should mention if I set it to -1 it has no problems besides going the completely wrong way.