After finishing a print and then G28 X Y the head ends up at 0,0,165.
I issue a G28 to start again. Everything homes to my min endstops.
Then it should advance to 55,77,0.9 which the GLCD shows.
But without measuring it i can see it is around 10,10 etc..
It is offset because i have an inductive sensor and it moves to what it thinks
is the middle of the bed. How 55,77 is the middle of a 200x200 bed i dont know.
Oh the version is 1.0.2
Andrew
I issue a G28 to start again. Everything homes to my min endstops.
Then it should advance to 55,77,0.9 which the GLCD shows.
But without measuring it i can see it is around 10,10 etc..
It is offset because i have an inductive sensor and it moves to what it thinks
is the middle of the bed. How 55,77 is the middle of a 200x200 bed i dont know.
Oh the version is 1.0.2
Andrew