Angles are correct for my setup, they work fine in 1.0.2.
Tried setting num_servos to 3, no change. M401/M402, both just move z up. M280 does nothing.
Won't compile without at least one of the endstop defines set.
Even tried compiling in 1.5.6r2, no change.
DEACTIVATE_SERVOS_AFTER_MOVE is defined since the servo always randomly moves down without it. Servo powered by it's own 7805.
1.0.2 will retract the servo on reset, 1.1.0 RC3 doesn't.
Tried setting num_servos to 3, no change. M401/M402, both just move z up. M280 does nothing.
Won't compile without at least one of the endstop defines set.
Even tried compiling in 1.5.6r2, no change.
DEACTIVATE_SERVOS_AFTER_MOVE is defined since the servo always randomly moves down without it. Servo powered by it's own 7805.
1.0.2 will retract the servo on reset, 1.1.0 RC3 doesn't.