i do have moved to RC, and i have new problems :)
i managed to make a compilable marlin, and put it in my mks. I asked a G28 and only the x rail is moving which is not good, i need the three rail to move together cause otherwise it break the rods (not reallly, its magnet system).
So i put the effector with my hand near the endstop approximately on the printer's vertical axe, X went to endstop nicely, Y too but Z stay where he is and after 5 seconds seems to be happy with his job, like he successfully homed.
marlin is hard ^^
tell me which information you need to help me my friend :)
i managed to make a compilable marlin, and put it in my mks. I asked a G28 and only the x rail is moving which is not good, i need the three rail to move together cause otherwise it break the rods (not reallly, its magnet system).
So i put the effector with my hand near the endstop approximately on the printer's vertical axe, X went to endstop nicely, Y too but Z stay where he is and after 5 seconds seems to be happy with his job, like he successfully homed.
marlin is hard ^^
tell me which information you need to help me my friend :)