My Z-Probe is working and the UBL system works for me too.
Just over the LCD control panel the UBL works not always
Just over the LCD control panel the UBL works not always
Quote
VBen
But i found a Bug, the compensation does not work under several conditions with manual control by LCD
Steps to reproduce:
1. A Z-max endstop setup is used for homing
2. after homing Z=0 should be some mm over the bed.
3. autolevel via G29 P0 T M A
4. activate again with G29 A
5. lower z by the LCD to Z=0 on display
6. the nozzle is now some mm over the bed and the compensation feature does not work for moves along x or y axis using the LCD panel
to get it work:
7. Execute G0 Z1
8. the nozzle is going down, the display shows Z=1
9. Use the lcd to move along x or y axis . These moves are now compensated