I have the same problem after switching form RC6 to RC7
I'm using the following setup for my printer:
-ZMAX hall endstop for homing
-servo deployable probe for bed leveling
After homing(G28) Z=0 is about 3mm over the print surface and then corrected by the bed leveling(G29).
This gives me the possibility to change the thickness of the build without adjusting the z-endstop.
Is there any solution for RC7?
I'm using the following setup for my printer:
-ZMAX hall endstop for homing
-servo deployable probe for bed leveling
After homing(G28) Z=0 is about 3mm over the print surface and then corrected by the bed leveling(G29).
This gives me the possibility to change the thickness of the build without adjusting the z-endstop.
Is there any solution for RC7?