I am trying to install an inductive sensor on my Prusa i3 Steel, using a SAV MkI as a board. I managed to get the sensor to trigger correctly with this version of Marlin - I installed with Arduino IDE 1.0.6 and USBtinyISP.
Unfortunately this firmware has the problem that the Z axis will not raise before the homing of X and Y and this could cause the nozzle to drag over the print surface. This issue was supposedly fixed with the latest BugFix, but I find no way to install the new version - the Sav MkI won't connect with the Arduino IDE 1.6.9 . What can I do?
Unfortunately this firmware has the problem that the Z axis will not raise before the homing of X and Y and this could cause the nozzle to drag over the print surface. This issue was supposedly fixed with the latest BugFix, but I find no way to install the new version - the Sav MkI won't connect with the Arduino IDE 1.6.9 . What can I do?