As per thread title. The first thing I printed on my Ender 5 was the cat from their SD card, and the way the carriage banged into the end stops was shockin' missus!
I've read that the firmware can be altered to reduce the homing speeds. So do I need an update? As I can't imagine there's any way to make changes through the basic control board.
Which firmware is currently recommended?
Thanx in advance to any assisting peeps.
I've read that the firmware can be altered to reduce the homing speeds. So do I need an update? As I can't imagine there's any way to make changes through the basic control board.
Which firmware is currently recommended?
Thanx in advance to any assisting peeps.