Hi folks
The beastie appears to be working but I have issues with G28 misbehaving.
The gcode for my prints finish with the following.
G1 Z165
G28 X Y
Nothing out of the ordinary here.
My gcode startup has the usual temp commands and
G28
G29
Still nothing amazing here.
What is odd is everytime a print starts and runs the G28 it homes to zero correctly.
But it then only moves 1/3 of the way to the middle of the bed but the GLCD is reporting
the head being in the middle of the bed. Oh, the G29 gets screwed up obviously.
The problem is easily fixed by sticking a second G28 in the startup but I would like to know
what is happending.
Suggestions?
Andrew
The beastie appears to be working but I have issues with G28 misbehaving.
The gcode for my prints finish with the following.
G1 Z165
G28 X Y
Nothing out of the ordinary here.
My gcode startup has the usual temp commands and
G28
G29
Still nothing amazing here.
What is odd is everytime a print starts and runs the G28 it homes to zero correctly.
But it then only moves 1/3 of the way to the middle of the bed but the GLCD is reporting
the head being in the middle of the bed. Oh, the G29 gets screwed up obviously.
The problem is easily fixed by sticking a second G28 in the startup but I would like to know
what is happending.
Suggestions?
Andrew