Thanks for the suggestion Roxy.
Yes I have it going now with the servo.
I changed to a different RAMPS board selection a few times until I found the one that works.
Still having some issues with the leveling though.
It all works fine except that at the far front and the far back the bed is too low. The bed is pretty flat using a straight edge to test.
I am now using 16 probe positions to see if that makes it any better, not tried it out yet with a long thin print to test.
.
Yes I have it going now with the servo.
I changed to a different RAMPS board selection a few times until I found the one that works.
Still having some issues with the leveling though.
It all works fine except that at the far front and the far back the bed is too low. The bed is pretty flat using a straight edge to test.
I am now using 16 probe positions to see if that makes it any better, not tried it out yet with a long thin print to test.
.