Quantcast
Channel: Reprap Forum - Firmware - Marlin
Viewing all articles
Browse latest Browse all 12090

Re: MKS SGen L V1.0

$
0
0
Quote
Dust
You sure the stepper modules are in correctly?

with mks the pins are color coded black to black and green to green

Steppers are in correctly.

Maybe it was a bad initial flash.

I did as the wiki suggested and deleted the files from the sdcard of the board. Then I powered down, disconnected all connections (only had the graphics controller connected) and waited 30 seconds instead of 10. Reconnected the controller and powered up, then rebuilt and uploaded the firmware and the error is now gone.

Weird. But now moving on again.

Thanks so far Dust for your responses (tu)

Viewing all articles
Browse latest Browse all 12090

Trending Articles