Thanks Roxy, I cant wait for the new release to be finished. I have gotten my prints to be uniform and precise with slight adjustments using the Delta Diagonal Rod trim.
But unfortunately even a 20mm cube digs in on the corner even though it is accurate to 0.05mm. I have shimmed up all the ball links at the Carriages to get them uniform as well as at the effector.
But I am using the effector that pushes the nozzle to activate the z switch.
[www.thingiverse.com]
[www.thingiverse.com]
Might try printing a standard effector and setting that up.
Once again thanks for Replying.
Regards Pete
But unfortunately even a 20mm cube digs in on the corner even though it is accurate to 0.05mm. I have shimmed up all the ball links at the Carriages to get them uniform as well as at the effector.
But I am using the effector that pushes the nozzle to activate the z switch.
[www.thingiverse.com]
[www.thingiverse.com]
Might try printing a standard effector and setting that up.
Once again thanks for Replying.
Regards Pete