Hi Roxy thanks for the reply, I'm running RC6. My delta is using the grid levelling.. But sorry I'm not aware if there is another method apart from the manual level that I done when setting up the endstops.
The print is always fading away due to the nozzle being too close in same places. The stupid thing is that even if I manually adjust by lowering the corner of the bed before print it will compensate next print by lowering the
nozzle against the bed again lol.
The print is always fading away due to the nozzle being too close in same places. The stupid thing is that even if I manually adjust by lowering the corner of the bed before print it will compensate next print by lowering the
nozzle against the bed again lol.