Quote
o_lampe
You are using absolute coords, so the nozzle goes up to 5mm and then at the beginning of the print it goes down to 0.3 ( 1st layer height? )
Looks normal to me.
Thanks o lampe,
What I was trying to point out was the problem with this line of code, Z0.297 at F3600. To expect any kind of accuracy when you move this distance at this speed is crazy. Maybe it works on other setups but it's disastrous on mine. Experience has pointed out to me that every time this code is run I end up with a different result. This affects the rest of the print job, inasmuch as the initial height above the print bed is randomized.
My question is how is this being put in to the code when slicer runs? Could it be the code in slicers print settings/start G code, or is it coming from somewhere else? Whatever the case I need to remove it or it ruins my print, I can do this manually but I would prefer not to have to do that. Is there some way to prevent slicer from putting this in?