Hi,
I have a Mendel90 running Marlin on a Melzi board and a panelolu2.
In the panelolu2 I have a meny entry that says "Set home offset".
What does this do and how are you supposed to use it?
I thougt it could be used to set Z-home so that I do not need to update firmware everytime that needs to change. But I cannot figure out how to use it.
Cheers
Tobbe
I have a Mendel90 running Marlin on a Melzi board and a panelolu2.
In the panelolu2 I have a meny entry that says "Set home offset".
What does this do and how are you supposed to use it?
I thougt it could be used to set Z-home so that I do not need to update firmware everytime that needs to change. But I cannot figure out how to use it.
Cheers
Tobbe